Topic: Trying to Upgrade 5.1.2

[steve]

When trying to update to 5.1.2 update 1
After agreeing to the liicense
I received this error message

You are about to install the SMEServer-5.1.2_Update1 blade.
An error occurred while fetching the software license agreements for SMEServer-5.1.2_Update1-02.noarch:
Could not receive data from blades server

Every time that i try to connect to the blade server I get the same message

What next?  Thanks sls

[steve]

After several more attempts, a reboot, 45 minutes, and several more attempts, I finally connected to the blade server and installed the update 1.  Thanks. sls

[Laurence Griffiths]

I think that everybody and his dog must be trying to install those updates. The blades server is probably working its little butt off!

I am trying to update three servers through three different ISP's and all of them are struggling.

If I continue struggling, I'll leave it until next week when the load on the blades server will hopefully have subsided a bit.

[Confucius]

Who can help me when the 'blade-runner' stays in a unknown state.. ??

I tried to update using blades, everything seemed ok.. No overloaded server no special things to mention... but then it should start working. That's where it goes wrong. I still see the same 5 percentage bars and it stays forever like that. By now I manually installed the updates but the blades-panel stays the same and no matter what http daemon I restart it stays the same.

Pls help...

Grtx, Harro

[Confucius]

Forget the previous post pls... I should try some buttons sometimes... didn't try the CLEAR button, now all is back to normal again..

[Alex Henriksen]

I have a error to on my SME 5.1.2:

An error occurred while fetching the list of available blades
Could not receive data from blades server

Anyone know why i get this error..??

[Lars]

I get the same error as Alex. I guess the reason nobody can connect is the fact that everybody is trying to connect...

Regards

[Alex Henriksen]

I DL the updates from the ftp site, but i still get the error in blades.??

But my PHP is now a version 4.0.6.