Topic: SME 7.2 + SAIL

[SARK devs]

HI mate,

I can't swear to -502 being correct but I've just put a fresh -505 on a clean box (no previous) and they are there.  Because they all start lower case they are at the bottom of the list - did you scroll right down to the end?  

I'll just put -505 onto the ftp server for you now.......


Done... You just forced a release - let us know how you get on...



Best

p.s. well spotted on the typo - we've fixed it - thx.

S

[groutley]

Hi Selintra,
  perhaps I am missing something ?
I am running 2.1.15  not 2.1.14
you have -505 on FTP site for 2.1.14 not 15.

Should I be running .14 ? If so, how do I go back to that level ?

I also have only been pulling the code from the FTP site,
I actually get lost with the diferent locations to download the sme-asterisk compared to selintra-sail  but its probably just my simple mind.

Also, the notes I have read suggests this new release provides provisioning for Cisco IP phones ?  Do you still want details on what I did to make it work ?  I have been caught up with work commitments and not got to documenting it yet. So have you beaten me to it ?

Thanks again for your help

[SARK devs]

Ah...

That would explain the discrepency.  The work has not been retrofitted to 2.1.15 yet.  It is only available in 2.1.14, which is our production release.  2.1.15/1.4.1 is still very much a beta release.  Sorry, to confused you and give bad advice.  -502 is 1.15 - I missed that release, they put it out for a small update on the .15 tree.

For production we would recommend 1.14 - there is nothing to your advantage in 1.15 at the moment except bugs in asterisk.  To regress just rpm -e the sail and asterisk rpms.  Install 1.2 asterisk and zappri and then you can install 2.1.14-505.  This takes longer to explain than it does to actually do .   It's only a two minute job.

Best

S

[del]

Hi Selintra,

I am still running the following rpms:
selintra-sail-2.1.14-339.noarch.rpm
smeserver-asterisk-1.2.10-3.i686.rpm
smeserver-asterisk-zappri-MPP-1.2.6-1.i686.rpm
smeserver-asterisk-sounds-1.2.2-2.noarch.rpm
I now they are old, but it works flawlessly so I have been reluctant to upgrade I even got the hardware to build a better box, but never got round to it My question, is you don't mention the smeserver-asterisk-sounds-1.2.2-2.noarch.rpm so is this not needed anymore? Just wanted to know because sooner or later I will build that better box  Thanks.
By the way I decided to order a couple of Snom 300 phones.

Regards,
Del

[SARK devs]

Hi Del

Hope you are well.

Regarding sounds.  If you are using Asterisk US sounds then yes you should still install the sounds pack 1.2.2

Regarding phones.  The Snom 300 is a good unit.

Best

S