Topic: NUT Problem SME 7.2 with APC SMART UPS 750

[dany_it]

I've have a problem with a APC SMART-UPS 750.

I've tried to type

Code: [Select]


config setprop nut status enabled

But it seem to don't work:

Code: [Select]

upsc UPS@localhost
Error: Driver not connected

Nut configuration is:

Code: [Select]

config show nut
nut=service
    MasterPass=914786031792523
    Model=usbhid-ups
    SlavePass=262189897836908
    status=enabled

I've another Sme (version 7.0, not 7.2) with the same UPS and the configuration works fine, with the Model: newhidups

I've tried to change the Model with:

Code: [Select]

config setprop nut Model newhidups
but when I reconfigure and reboot the server it isn't saved and the configuration was the previuos.

Can you help me?

Thank you!

Bye,
Daniele.

PS: sorry for my bad english...!

[thomasch]

I've have a problem with a APC SMART-UPS 750.

I've tried to type

Code: [Select]


config setprop nut status enabled

But it seem to don't work:

signal-event post-upgrade
signal-event reboot

or without rebooting:

expand-template /etc/sysconfig/ups
expand-template /etc/ups/*
service nut start

[dany_it]

Yes,  I know that is necessary signal-event post-upgrade; signal-event reboot, and I have do it.

I think the problem is the driver "usbhid-ups" that doesn't work with my Ups, eventought the previoos "newhidups" works fine...

[Stefano]

Per Daniele.. scrivi ANCHE sul forum in italiano

Code: [Select]

[root@fileserver ~]# config show nut
nut=service
    MasterPass=mymasterpass
    Model=usbhid-ups
    SlavePass=myslavepass
    status=enabled


Code: [Select]

[root@fileserver ~]# grep 'American' /var/log/messages*
.....
May  1 21:44:45 fileserver upsdrvctl: Detected a UPS: American Power Conversion/Smart-UPS 750 FW:651.12.I USB FW:4.2
.....

check your cable

HTH
Ciao

Stefano

[dany_it]

Grazie Stefano...

Code: [Select]

grep 'American' /var/log/messages*
...
Nov 29 14:31:34 svrlinux kernel: hiddev96: USB HID v1.10 Device [American Power Conversion Smart-UPS 750 FW:651.13.I USB FW:7.3] on usb-0000:00:1d.3-1
...
The cable is OK... What's the problem?