Topic: FTP Problem - How to set a FTP client as PASV mode

[m4oz!nh4]

Hi everyone,

Can someone please help me with accessing this external ftp site using sme

before hand, here are the setups in server-manager for sme:
FTP access: local network
FTP password access: loca network password

O know I need to make my FTP client is using PASV mode but I dont know where to go to change !

thanks in advance.

[cactus]

Hi everyone,

Can someone please help me with accessing this external ftp site using sme

before hand, here are the setups in server-manager for sme:
FTP access: local network
FTP password access: loca network password

O know I need to make my FTP client is using PASV mode but I dont know where to go to change !

thanks in advance.

I am not completely clear on what you want or trying to do.

Setting FTP access to be only local and then trying to access it from outside your network (external) will not work, you will need to change your FTP access settings.

If you are trying to access an external FTP site from behind your gateway you do not have to bother about the FTP settings as they concern the settings of the FTP daemon on your SME Server, setting you client to passive is outside the scope of this forum, you will need to read the manual of your FTP client...

[m4oz!nh4]

you are right cactus! I Wrote whong!

the setups in server-manager for sme are:
FTP access: public
FTP password access: local network passwords

the problem was, I can not see the FTP server for inside the network (when I did the ping of ftp.domain

[cactus]

you are right cactus! I Wrote whong!

the setups in server-manager for sme are:
FTP access: public
FTP password access: local network passwords

the problem was, I can not see the FTP server for inside the network (when I did the ping of ftp.domain

I don't believe you can access your server from outside. I always set it to enable passwords from local and remote if I need it: http://wiki.contribs.org/SME_Server:Documentation:Administration_Manual:Chapter11#FTP

[m4oz!nh4]

so, I already read the documentation bu I read (again) the documentation that you sent me and sorry, but I am already did the setup as documentation says and I can not ping FTP from inside the network as I do with the Email server (ping <<name_of_server>>.domain. may I use the ping command wrongly ??

tks

[CharlieBrady]

O know I need to make my FTP client is using PASV mode but I dont know where to go to change !

That's entirely up to whatever FTP client you are using, and has nothing to do with any SME server setting.