I have a SME 7.4 with a single SATA 160G for boot and some storage but it is getting full and I'd like to add an internal 1T SATA raid10 using two 1T SATA drives. Again, this would be in addition to the boot disk. Are there any problems I should be aware of before I start? Is there a HowTo? Most of what I have found is for SATA boot drives or not relevant to extra internal storage. I have installed the drives and the system recognizes them as sdb and sdc and returns the correct drive specs but I have not formatted them yet. Any help or suggestions is appreciated.
Below is the output of smartctl -i /dev/sdb; smartctl -i /dev/sdc
=== START OF INFORMATION SECTION ===
Device Model: Hitachi HDS721010CLA332
Serial Number: JP2921HQ23YT6A
Firmware Version: JP4OA39C
User Capacity: 1,000,204,886,016 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: Not recognized. Minor revision code: 0x29
Local Time is: Thu Jul 1 10:21:50 2010 PDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF INFORMATION SECTION ===
Device Model: Hitachi HDS721010CLA332
Serial Number: JP2921HQ23B6YA
Firmware Version: JP4OA39C
User Capacity: 1,000,204,886,016 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: Not recognized. Minor revision code: 0x29
Local Time is: Thu Jul 1 10:21:50 2010 PDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled